Net metering is available to customers who generate electricity using solar, wind, hydroelectric, geothermal, biomass, biogas, combined heat and power (CHP) or fuel cell technologies. The ACC has not set a firm kilowatt-based limit on system size capacity; instead, systems must be sized to not exceed 125% of the customer’s total connected load. If there is no available load data for the customer, the generating system may not exceed the customer’s electric service drop capacity.
Mohave Electric Cooperative provides incentives for its customers to install renewable energy systems on their homes and businesses. Mohave Electric Cooperative will provide rebates for residential and commercial photovoltaic (PV) and wind systems. Rebates for solar water heating are available only for residential systems. Customers must meet all the applicable terms and conditions and submit the appropriate forms provided at the website listed above.
Mohave Electric Cooperative is a non-profit that serves the communities of Bullhead City, Fort Mohave, Mohave Valley, Wikieup, Hackberry and Peach Springs. Mohave Electric Cooperative offers rebates for installation of energy efficient heat pumps. Installations must meet all program efficiency requirements in order to receive rebate. To see forms and additional information on these rebates, please go to the website above.
The Maricopa County Zoning Ordinance contains provisions for siting renewable energy systems. The ordinance defines renewable energy as "energy derived primarily from sources other than fossil fuels or nuclear fission." Renewable energy systems may be built in any zoning district within the county as long as certain siting requirements are met.
Setbacks: Renewable energy systems must be set back at least 3 feet away from the side or rear lot lines. Setback requirements for front lot lines and for corner lots vary by zoning district.
In an effort to promote uniformity, the Maricopa Association of Governments (MAG) approved standard procedures for securing necessary electrical/building permits for residential (single-family) and commercial PV systems. These procedures are a part of the MAG Building Code Standards. The standards address requirements for the solar installation, plans, diagrams, applicable warnings, and signage. The same standards were adopted by the City of Scottsdale, although many other cities in the Phoenix area are using them as well.
The Arizona Corporation Commission requires electric utilities to conduct a cost/benefit analysis to compare the cost of line extension with the cost of installing a stand-alone photovoltaic (PV) system for remote locations with electricity needs. This ruling applies to Arizona Public Service (APS), Tucson Electric Power (TEP), Arizona Electric Power Cooperative and Navopache Electric Cooperative.
'''''Note: In June 2007, the Arizona Corporation Commission (ACC) initiated a rulemaking process to establish statewide interconnection standards for distributed generation (DG). This proceeding is still in progress. Until the new official rules go into effect, the commission has recommended that the utilities use the [http://images.edocket.azcc.gov/docketpdf/0000074361.pdf Interconnection Document] as a guide. This document applies to systems up to 10 megawatts (MW) in capacity. '''''